How To Fix The Error Code C8 For GE Dishwasher

(Many of the links in this article redirect to a specific reviewed product. Your purchase of these products through affiliate links helps to generate commission for Storables.com, at no extra cost. Learn more)

Is your dishwasher overfilling? Learn how to fix the C8 error code!

There’s nothing more frustrating than a dishwasher that overfills, causing water to spill out onto your kitchen floor. If you’re experiencing this issue, chances are you’ve encountered the C8 error code on your GE dishwasher. But fear not! In this article, we will guide you through the steps to fix this problem and get your dishwasher back to its normal, efficient self.

What is the C8 error code and what causes it?

The C8 error code on a GE dishwasher indicates that it is overfilling. This issue is often related to a malfunctioning float switch or water inlet valve.

Float switch: The float switch is a small device located at the bottom of the dishwasher. Its purpose is to monitor the water level in the tub. When the water reaches a certain level, the float switch will automatically shut off the water flow. If the float switch gets stuck or malfunctions, it can cause the dishwasher to overfill.

Water inlet valve: The water inlet valve is responsible for allowing water into the dishwasher. If the valve is faulty or clogged, it may not close properly, resulting in the dishwasher overfilling.

To fix the error code C8 on a GE dishwasher, try resetting the dishwasher by unplugging it for a few minutes and then plugging it back in. If the error persists, it may indicate a problem with the water inlet valve or the control board, and professional service may be required.

How to fix the C8 error code

1. Check the float switch: Before doing anything else, locate the float switch in your dishwasher. Gently lift it up and down to ensure that it moves freely. If you notice any resistance or if the switch feels stuck, it may need to be cleaned or replaced. Consult your dishwasher’s manual or contact a professional for further assistance.
2. Inspect the water inlet valve: The next step is to inspect the water inlet valve. Start by turning off the power supply to the dishwasher. Then, locate the valve, which is typically located behind the lower access panel or underneath the dishwasher. Carefully examine the valve for any signs of damage or debris. If you notice any clogs or visible issues, it may be necessary to clean or replace the valve. Again, it is recommended to consult a professional if you are unsure or uncomfortable performing this task.
3. Reset the dishwasher: After checking and potentially fixing the float switch and water inlet valve, it’s time to reset your dishwasher. To do this, turn off the dishwasher’s power supply at the circuit breaker or unplug it from the wall. Leave it unplugged or switched off for a few minutes. Then, restore power and try running a test cycle to see if the C8 error code persists. If the code reappears, it may indicate a more severe underlying problem, and it is advisable to seek assistance from a qualified technician.

Remember, safety is paramount when working with any electrical appliance. If you’re unsure about any of the steps or feel uncomfortable performing them yourself, it’s always best to consult a professional technician to ensure proper and safe repairs.

By following these steps, you can take control of the C8 error code on your GE dishwasher and restore its normal functionality. Don’t let an overfilling dishwasher dampen your day. Get it fixed, and get back to enjoying clean and hassle-free dishwashing!